UGREEN X767 65W Charger Under-Desk Slide Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Slide-in under-desk holder for the UGREEN 65W 5-port GaN charger (X767). Glue or screw it on, no supports needed.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 5
- Makes
- 0
- Views
- 34
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution
Under-desk slide mount for the UGREEN 65W 5-port GaN desktop charger (model X767, 4x USB-C + 1x USB-A, 73 x 69 x 29 mm).
How it works
C-shaped rail that you stick (3M VHB tape) or screw under your desk.
Slide the charger in from the front, ports facing you: it clicks over two flexible tabs.
Fixed stop at the back (plugging cables in won't push it out), clips at the front (unplugging won't pull it out).
To remove it: push the two tabs down from below and pull.
Open back for the AC cable, open bottom and side windows for airflow.
4 optional 4.5 mm screw holes.
Printing
The STL is already oriented: front face on the bed. No supports needed. A brim is recommended (the part stands 84 mm tall).
PETG or ASA recommended (the charger gets warm). 0.2 mm layers, 4 perimeters, 15-20% infill.
Size: 104 x 84 x 36 mm, about 50 g.
v2: +3 mm depth clearance so the front clips snap fully into place.
Before printing
Dimensions come from UGREEN's spec sheet (port face 73 mm wide, 69 mm deep, 29 mm thick). Please measure your charger first. If needed, edit CH_W / CH_D / CH_H at the top of the included Python script (uses manifold3d + trimesh) and regenerate the STL. Tip: cut the first ~12 mm in your slicer to test-print the cross-section and the front clips.
