Canopyrod handle for Schleicher Flugzeugbau ASK 13
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Knob for ASK13 canopy. Required 4 times plus one M6 (selflocking-)nut and washer each. Picture 2 shows a testprint...…
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 7
- Makes
- 0
- Views
- 194
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution
Knob for ASK13 canopy. Required 4 times plus one M6 (selflocking-)nut and washer each.
Picture 2 shows a testprint... the rod should be covered, too.
Print Settings
Printer Brand:
Anet
Printer:
A8
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.2
Infill:
10%
Filament: NuNus PETG translucent red Post-Printing =============
Printed as arranged in STL, just remove the support an xou are good to go.
The M6 nut goes tight and snug into the the hex hole. (small hammer) the washer goes onto the canpys rod. I heated up he washer with a flame and screwed the knob on to weld the washer with the knob.
Category: DIY