Ghetto QNAP
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Introducing Ghetto QNAP! (QNAP TS451 converted to an Odroid H4+)
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 3
- Makes
- 0
- Views
- 99
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
QNAP TS451 converted to an Odroid H4+
My QNAP TS451 motherboard died, so I ripped out the guts and created a Ghetto QNAP! I run Proxmox on mine with ZRAID, and Openmediavault as a VM for the NAS storage, its incredibly faster than the old slow QNAP motherboard. Obviously you'll need an ODroid H4+ from Hardkernel https://www.hardkernel.com/ with eMMC storage to run your desired OS (I chose Proxmox) and re-use your SATA disks (I configured using ZRAID) I use Veeam backup and replication community edition on my PC to backup the VMs that run on this (OMV, Docker and a few others) to a disk on my PC. All free software.
Requires a few other components to buy as well (4 x SATA 7+15 to SATA 7pin data power cables, I think I needed 0.4m lengths) https://www.aliexpress.com/item/1005005728153913.html
I designed and built this over a year ago, so can't recall exact details but fairly certain I allowed for the design to re-use the QNAPs screws where possible as things were removed. I think I use a ballpoint pen spring and M3 screws for the buttons.
A new back plane design allows for everything to fit (note the square holes on the backplane are for cable ties to hold the SATA cables) and top mount the Odroid, so needs a bit of drilling and dremel tool to cut a hole for the wires and cables. You'll also have to move the fan to the outside of the box (3D case included for this) to allow room inside the QNAP.
If you want to print and use this and get stuck, post a comment and I'll shutdown my ODroid and upload some internal photos. But it should be fairly straightforward. Everything should print as is except from memory I think the backplane needed supports. Print the button components 100% in fill.