Modified INDX tool holder for magnets D5 x 8 mm (captive & back inserted) and D4 x 10 mm (captive)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Modified INDX tool holder for stronger magnets, to fix tool parking failures. Captive or back-inserted magnets.
- Rating
- 5 / 5
- Likes
- 7
- Downloads
- 11
- Makes
- 3
- Views
- 226
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Open Community License v1.1
I ordered a set of 8 0.25 mm INDX nozzle tools from Bondtech directly. The plastic part on the tools supplied by Bondtech have a much rougher surface finish than that on the 0.4 mm tools supplied with the INDX kits from Prusa. See the photo below as an illustration. (Left: 0.4 mm nozzle tool from INDX conversion kit purchased from Prusa. Right: 0.25 mm nozzle tool supplied directly by Bondtech.)

My Core One + INDX kit as supplied worked very well with the supplied 0.4 mm tools. But with the 0.25 mm tools supplied by Bondtech directly, I started experiencing frequent tool parking failures.
MIRE's modified tool holder with stronger magnets seemed like a good possible solution. I didn't have D4 x 10 mm magnets readily available, but I did have some D5 x 8.5 mm magnets, so I made a tool holder version for these.
I designed the following variants:
Variant for D5 x 8 mm or D5 x 8.5 mm magnets, back-inserted into the tool holder.
Variant for D5 x 5 mm magnets, captive in the tool holder.
Variant for D5 x 8 mm magnets, captive in the tool holder.
Variant for D5 x 8.5 mm magnets, captive in the tool holder.
Variant for D4 x 10 mm magnets, captive in the tool holder.
Print as recommended for the standard part: PETG, 0.4mm nozzle, 0.2mm layer height, 20% gyroid infill.
For the captive versions, add a pause in the slicer at the start of the first layer above the cavity for the magnet. When the print pauses, add the magnet (pay attention to the required orientation/polarity), and then continue the print.
I tested variants 4 and 5. With both, after installing them, I successfully completed several multi-color 0.25 mm nozzle prints, confirming that it works!




