Horizontal Balcony Rail Mount – SenseCAP Solar Node P1
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Balcony railing mount that holds a Seeed SenseCAP Solar Node P1 horizontally - one-piece PETG print
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 1
- Makes
- 0
- Views
- 33
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
A one-piece holder that lets a Seeed Studio SenseCAP Solar Node P1 (or P1-Pro) live horizontally on a balcony railing instead of a wall or a mast.
WHY THIS PART EXISTS
The Solar Node P1 is built to be bolted to a wall or clamped to a mast. On a balcony you usually have neither - but you do have a railing. This mount turns that railing into a mount point:
the open cradle seats onto the round railing tube and centres itself
the full length of the cradle rides along the rail, so the load is spread over roughly 90 mm instead of hanging off a single point
the flat back face is your mounting interface for the node's bracket or panel
four through-slots take a cable tie, strap or antenna clamps to lock the holder onto the rail and to keep the drop cable tidy
SPECS
Holes are vor M6 screws
The SenseCAP screw holes are not square - you can only use this in a horizontal setup
The rail diameter is designed this for is about 33mm.
PRINT SETTINGS
Layer height: 0.25 mm
Perimeters: 4
Infill: 20 % gyroid
Solid layers: 3 bottom / 4 top
Supports: auto, snug, 40 degree threshold
Brim: none
Material: I used PETG since it grips well at the railing and is ourdoor-safe
COMPATIBILITY
Designed for the Seeed Studio SenseCAP Solar Node P1 / P1-Pro (same enclosure) and the mounting bracket provided in the package.
Printed it? Post a make - I would like to see it up on a balcony.
Happy meshing!