1 / 12
Chitu E1 Filament Dryer – PTFE Pass-Through (M10x1) + Cut Template — image 1
1 / 12

Chitu E1 Filament Dryer – PTFE Pass-Through (M10x1) + Cut Template

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

PTFE pass-through for the Chitu E1 dryer (PC4-M10 / M10x1) with extra-wide flanges + cut template. STEP included.

Rating
0 / 5
Likes
0
Downloads
1
Makes
0
Views
31
Reviews
0

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution — Noncommercial — Share Alike

I redid this from scratch because I wasn't happy with the existing solutions, mostly for printability. Everything on them was rounded for no reason and the edges were really narrow.

I made all the flanges much wider. That gives you a lot of tolerance when cutting the wall with the template: if your cut is a bit off, the wide flanges still cover the gap cleanly on both sides. You can fill the gaps with a bit of glue if you like, but I don't think it's really necessary. It should seal fine without it.

The threaded tube is now a clean CAD body. It is no longer an imported STL mesh, so the STEP files are fully editable.

How it works

  1. Hook the cut template (the flat part) over the rim of the dryer bowl where you want the pass-through.

  2. Trace the U-shaped slot with an Edding or any other marker.

  3. Cut out the marked U with a Dremel (cut-off wheel), then clean up the edges.

  4. Slide the connector into the cut from above. The 2.7 mm gap clamps the wall, and the wide flanges cover the cut edges inside and out.

  5. Screw a PC4-M10 coupler into the M10x1 thread and run your PTFE tube to the printer.

Features

  • Real modelled M10x1 internal thread (10.2 mm major Ø for a printable fit), 6.8 mm long

  • 48° tube angle, so the filament leaves the spool with a smooth bend

  • Tapered stop for the coupler nose and a funnel (Ø3.9 → 12.6 mm) so the filament feeds in easily

  • 24 × 30 mm flanges, 1.5 mm thick, with an extra 1.5 mm overlap at the bottom of the outer flange

  • No supports needed

Print settings

  • Material: PETG / ASA / ABS (the dryer gets warm, so don't use PLA)

  • Layer height: 0.12–0.16 mm (better thread quality)

  • Walls / infill: 3–4 walls, 30 %+ infill

  • Supports: none. Print as exported, standing on the flange edge

Hardware

  • 1× PC4-M10 push-fit coupler

  • PTFE tube 4 mm OD / 2 mm ID

Tags