1 / 6
A heavier duty kind-of-608 pedestal bearing (straight and 90°) — image 1
1 / 6

A heavier duty kind-of-608 pedestal bearing (straight and 90°)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Based on 608 measurements but technically a single row cylindrical roller bearing with an inner nominal diameter of 8 mm

Rating
0 / 5
Likes
2
Downloads
23
Makes
0
Views
67
Reviews
0

Updated at source:

Model information

License
Open Community License v1.1 + GAtt v1 + Micro v1

A printable cylindrical roller bearing in a pedestal housing, built around the 608 standard. It takes an 8 mm shaft, but uses seven full-length cylindrical rollers instead of balls, so it can carry more load.

There are two housing shapes:

  • Straight: a classic pedestal bearing

  • 90°: a corner version for mounting into an inside corner or against two perpendicular surfaces

Each shape comes in two mounting versions:

  • Countersunk: for 3.5 mm countersunk screws, such as wood screws

  • Metric: with 4.5 mm holes for M4 screws

All parts except the housing are the same for every version. Print one housing of your choice plus the bearing parts. You'd need 7 rollers.

Key dimensions

  • Shaft bore: 8 mm

  • Shaft center height: 12 mm above the mounting surface. On the 90° version this applies to both mounting faces.

  • Housing width (axial): 14 mm

  • Footprint:

    • Straight: 54 × 24 mm

    • 90°: 39 × 39 mm

  • Mounting holes:

    • Standard: for 3.5 mm countersunk screws

    • M4 version: Ø4.5 mm for M4 screws

    • The straight version has its holes 43 mm apart.

  • Rollers: 7 × Ø3.5 × 11.75 mm, cylindrical with chamfered ends

Which mounting version?

  • 3.5 mm countersunk: for wood, MDF or plywood. The screw head sits flush with the foot.

  • M4: for metal profiles, threaded inserts or through-bolting with nuts. Use this when you want a stronger joint or need to take the bearing off and put it back regularly.

Print settings

  • Material: [PETG / PLA / …]

  • Layer height: [0.12–0.2 mm]

  • Infill: [x %]

  • Supports: [none / …]

  • Orientation: as provided in the STL files

Assembly

  1. Insert the 7 rollers into the cage.

  2. Place the cage with the rollers onto the inner race.

  3. Slide this assembly into the outer race.

  4. Press the outer race into the housing.

  5. Press the inner cap into the inner race to close the bearing.

[Add: lubrication / tolerances / tips]

Notes ⚠

  • The 90° version only rests on one side of the bottom face. It is designed for corner mounting, not for standing on a flat surface by itself.

  • This is a printed plastic bearing. It works well for low speeds and moderate loads, such as jigs, rollers, carts or prototypes. It does not replace a steel bearing at high speed or under high load.

Tags