Cat Cable Coiler w eraser box + sunglasses themed paper holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
It's a cat themed coil that you can wrap your cables around!
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 11
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial
(I have not printed this myself. Let me know if you do!)
Hi there! This is a cable holder that you coil your (typically phone) cable around. And it's small enough to fit in your pocket!
The best way to shorten cables is to loosely coil them. This method makes the cable less likely to short and makes storing them less of an overall nightmare. So, I made this to organize the process! It's intended to be used for phone chargers. but can really apply to any cable that's not too thick/long.
To assemble the Cable Holder:
Lay down the bottom piece so that its smaller protruding cylinder is facing you.
Align the square peg of the top piece with the square hole within the smaller cylinder of the bottom piece. Then push the top piece down until the two pieces are flush together.
And there you have it! That's the basic cable spool. But if you want to add the eraser & small paper holder addon, refer to the following.
Eraser Holder:
Note: To attach the eraser holder, you need a 10 mm M5-0.8 screw, 3D printed or otherwise.
Align the eraser holder's bottom piece so that its base sits on the spool's top piece. Make sure the hole of the spool's top piece is aligned with the hole in the base of the eraser holder.
Place an M5-0.8 screw onto the opening of the eraser holder's hole; then rotate the screw with a flat head screwdriver until the eraser holder bottom and the spool top are tight against each other.
Place the eraser inside of the eraser holder
Grab the top lid of the eraser holder. Make sure the lid's flat side is facing you, then push the lid tight against the eraser holder bottom
Holder of Very Small Paper:
This very small paper holder can hold paper that is 4.5 cm in width.
Place your paper between the two holes on the eraser holder's lid.
Align the sunglasses piece with the holes on the lid so that the cylinders are above the holes. Then, push the sunglasses piece down until the cylinders are in the holes and the piece can go no further.
And that's it! Now you have a tiny, fully assembled cat coiler to organize your cables. Enjoy!