Modular Photo Frame [10x15cm]
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I had poor quality photo frame that looked similar but the plastic broke and it wasn't expandable. So I designed my own.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 5
- Makes
- 0
- Views
- 59
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Home Decor
- License
- Creative Commons — Attribution
For standard 10x15 photos.
There's a bit of space for up to 1mm glass/plexi window cover. I didn't use one but If you want extra protection it's there.
No supports required.
Pins and mount can use brim, depending on your print setup.
L shaped pins have a Long and Short side. Short side goes into the side of the frame, Long side into bottom of the frame.
Mounting: 3M Command 17202WHI-4-PTRG Small: https://www.command.pl/3M/pl_PL/p/d/v101778047/
"pin-mount_distance" is for stabilizing the frame flex, it's similar to tape mount but adds thickness of the tape.
You don't need a lot of mounting points. I think it's safe to go for one tape every 12-20 frames.
Inserting photo:
Connecting frames:
As usual I'm adding f3d file, if you'd like to modify it in any way, but beware that I haven't cleaned it in any way, yet, so it might be tricky to figure out what is what.