1 / 6
Slat Wall Mirror Hanger: no-drill, self-tightening wedge clamp for acoustic slat panels — image 1
1 / 6

Slat Wall Mirror Hanger: no-drill, self-tightening wedge clamp for acoustic slat panels

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

No-drill mirror hanger for wood-slat acoustic panels. A wedge grips one slat by its sides and tightens under load.

Rating
0 / 5
Likes
0
Downloads
2
Makes
0
Views
47
Reviews
0

Updated at source:

Model information

Category
Home Decor
License
Creative Commons — Attribution — Noncommercial

Hooks for slatted acoustic panels usually clamp through the felt behind the slats: a flange twisted into the gap, pulled tight with a screw. The felt keeps squashing under the load, the clamp force fades, and the hook slowly slides down the wall. Mine did.

This one never touches the felt. It grips one slat by its two side faces, and the grip grows with the load.

How it works

  • The body sits on the front of one slat. A straight leg drops into the gap on the left and rests against the slat's left side. A sloped leg (4°) drops into the gap on the right.

  • A loose wedge is pushed up into the right-hand gap, between the slat and the sloped leg.

  • When the mirror pulls the body down, the sloped leg drives the wedge harder into the slat. If anything creeps, the body drops a fraction of a millimetre and tightens again.

  • Nothing presses on the felt or on the neighbouring slats. No screws, no holes, no glue.

Fitting

  1. Put the body on with its legs in the gaps either side of one slat, plate flat on the slat.

  2. Feed the wedge up into the right-hand gap from below, between the slat and the sloped leg, and push it up firmly by its thumb tab.

  3. Pull the body down hard once to seat it, then hang the mirror wire on the hook. A wax crayon or candle rubbed along the sloped leg first helps it tighten.

  4. To remove: lift the body and catch the wedge as it drops out.

Fits

Slats 25 mm wide with 14 mm gaps and 16 mm from slat face to felt (common oak/walnut-look panels). It tolerates slats from about 24 to 26.9 mm wide. For other panels, open slat-hanger.scad in OpenSCAD, measure your slat width, gap and depth, set slat_w, gap and slat_d at the top, and export print_body and print_wedge.

Load

Designed for a mirror up to 5 kg on a picture wire. Use two hangers on the wire for anything heavy; that halves the load on each. If the wedge ever slips on a very smooth slat foil, stick a strip of rubber (bike inner tube or anti-slip pad) on its slat face.

Printing

  • Body: print standing on its bottom end, as exported. The layers then run across the height, so the legs and hook bend along the layers rather than peeling them apart. The hook has a 45° chamfer underneath: no supports.

  • Wedge: lies flat on its slat face.

  • PLA or PETG, 0.2 mm layers, 4 walls, 40% infill. PETG creeps less under a long-term load.

Tags