4x U.2 SSD Caddy with 80 mm Fan - Stacked Open Frame (100x70x15 mm)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Stacked open-frame caddy for 4x 15 mm U.2 SSDs, side-screwed on 77 mm holes and cooled by an 80 mm fan.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 5
- Makes
- 0
- Views
- 16
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution
Open-frame caddy for four 15 mm thick U.2 (2.5") SSDs, stacked with 8 mm air gaps and cooled by a standard 80 mm fan.
HOW IT WORKS
- 16 M3 through holes (8 per side, 4 per column), 77 mm apart and 12 mm below the top face of each drive, with a countersink so a short M3x5 already reaches the drive thread.
- Drives go in from the back: there is no rear wall, so the connector stays accessible and you can pull a drive without disassembling anything.
- 4 guide lips per slot hold each drive while you screw it; 0.5 mm clearance to each wall.
- 12 mm air plenum behind the fan, so all four gaps get fed. The top has 4 wavy slots (49 % open area) as exhaust and the bottom is completely open.
- Sides are open frames: an 8 mm rim plus 2 wavy 10 mm columns per side. The wave is the top-slot motif rotated 90 degrees, with the wavelength tied to the drive pitch so all four screw holes land on the zero crossings.
- 3 small hooks under the lowest drive guide the fan cable, alternating up/down and at slightly different heights, so the thin wire weaves through and stays put. The cable enters through a notch in the bottom-right corner of the front plate that does not cut the side wall.
DIMENSIONS
88 x 121 x 105 mm overall (77 x 117 x 93 mm body + 4 mm fan plate). Interior 71 x 84 mm. 57.2 cm3, about 61 g in ASA.
PRINTING
- Orientation: fan plate on the bed, part standing up (88 x 93 mm footprint, 121 mm tall). The part is prismatic along the print axis, so there are no supports; the only overhangs are the 3 mm window edges and the 4 mm hook faces.
- ASA or ABS
- The 16 M3 holes and the 4 fan holes print clean; run a 3.4 mm drill through them if your printer is sloppy.
HARDWARE
- 16 x M3x5 (or M3x6) for the drives, gentle torque.
- 4 fan screws. The fan holes are dia 4.2 = the tapping drill for M5x0.8 (also the pilot for an M5 thread-forming screw), with a 45 degree countersink. If your fan screws are M4 thread-forming, set FAN_SCREW_D = 3.6 in the script.
MADE IN FREECAD, STILL BETA, I will post future fixes if needed
LICENCE
CC BY 4.0 - do whatever you want with it