1 / 7
4x U.2 SSD Caddy with 80 mm Fan - Stacked Open Frame (100x70x15 mm) — zdjęcie 1
1 / 7

4x U.2 SSD Caddy with 80 mm Fan - Stacked Open Frame (100x70x15 mm)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Stacked open-frame caddy for 4x 15 mm U.2 SSDs, side-screwed on 77 mm holes and cooled by an 80 mm fan.

Ocena
0 / 5
Polubienia
1
Pobrania
5
Wydruki
0
Wyświetlenia
16
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution

Open-frame caddy for four 15 mm thick U.2 (2.5") SSDs, stacked with 8 mm air gaps and cooled by a standard 80 mm fan.

HOW IT WORKS

- 16 M3 through holes (8 per side, 4 per column), 77 mm apart and 12 mm below the top face of each drive, with a countersink so a short M3x5 already reaches the drive thread.

- Drives go in from the back: there is no rear wall, so the connector stays accessible and you can pull a drive without disassembling anything.

- 4 guide lips per slot hold each drive while you screw it; 0.5 mm clearance to each wall.

- 12 mm air plenum behind the fan, so all four gaps get fed. The top has 4 wavy slots (49 % open area) as exhaust and the bottom is completely open.

- Sides are open frames: an 8 mm rim plus 2 wavy 10 mm columns per side. The wave is the top-slot motif rotated 90 degrees, with the wavelength tied to the drive pitch so all four screw holes land on the zero crossings.

- 3 small hooks under the lowest drive guide the fan cable, alternating up/down and at slightly different heights, so the thin wire weaves through and stays put. The cable enters through a notch in the bottom-right corner of the front plate that does not cut the side wall.

DIMENSIONS

88 x 121 x 105 mm overall (77 x 117 x 93 mm body + 4 mm fan plate). Interior 71 x 84 mm. 57.2 cm3, about 61 g in ASA.

PRINTING

- Orientation: fan plate on the bed, part standing up (88 x 93 mm footprint, 121 mm tall). The part is prismatic along the print axis, so there are no supports; the only overhangs are the 3 mm window edges and the 4 mm hook faces.

- ASA or ABS

- The 16 M3 holes and the 4 fan holes print clean; run a 3.4 mm drill through them if your printer is sloppy.

HARDWARE

- 16 x M3x5 (or M3x6) for the drives, gentle torque.

- 4 fan screws. The fan holes are dia 4.2 = the tapping drill for M5x0.8 (also the pilot for an M5 thread-forming screw), with a 45 degree countersink. If your fan screws are M4 thread-forming, set FAN_SCREW_D = 3.6 in the script.

MADE IN FREECAD, STILL BETA, I will post future fixes if needed

LICENCE

CC BY 4.0 - do whatever you want with it

Tagi