1 / 1
SC4/KW5 Lishi Spacer V2 (Official) — 4 mm Stand-Off — image 1

SC4/KW5 Lishi Spacer V2 (Official) — 4 mm Stand-Off

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Snug, flex-grip 4 mm spacers for SC4/KW5 Lishi tools. One-piece, support-free print with rounded edges.

Rating
0 / 5
Likes
3
Downloads
12
Makes
0
Views
66
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Noncommercial

These are the official 44 Delta Lishi Spacer V2 models for printing at home. They add 4 mm of spacing to compatible SC4/KW5 Lishi tools for use with a matching five-pin lock of the same keyway.

If you would rather buy them, the finished three-color packs are available here: Lishi Spacer V2 from 44 Delta.

Design Features

Internal contact pads and flexible gripping sections provide a snug fit around the larger rectangular area of the tool. Each flexing section is attached at both ends for support. Rounded edges, a smooth neck transition, and recessed equilateral triangle outlines finish the design.

This is a one-piece print with no screws, magnets, glue, or other hardware needed.

Project File Organization

Lishi Spacer V2 — contains Lishi Spacer V2.stl, the final single-piece spacer. Print one per tool. The same model fits SC4 and KW5 tools; the colors are just a preference.

Printing

  • Material: PLA, as used for the tested fit.

  • Print at 100% scale in millimeters.

  • Orient upright with the wide rectangular entrance on the bed and the narrower neck pointing up.

  • No supports required.

  • Suggested starting point: 0.2 mm layer height and 3 perimeters with a 0.4 mm nozzle.

Printer and filament tolerances affect the fit. Keep the internal opening and flexure slots clear of strings or first-layer flare.

Installation

  1. Feed the narrow shaft through the spacer, with the wide opening facing the larger etched rectangle.

  2. Keep it straight and push firmly onto the rectangle. Push past the initial resistance until the internal stop seats all the way against the shoulder. The tight fit is intentional.

  3. Check that the spacer sits straight and holds securely. When fully seated, the neck extends 4 mm beyond the top of the larger rectangular tool body, toward the tip.

Support the solid tool body during installation; avoid pressing on the movable picking arm. If it jams, check alignment and obstructions rather than hammering it on.

Illustrated instructions: Lishi Spacer V2 Installation Guide.

To remove it, grip the spacer body and pull straight toward the shaft tip. Avoid pulling on the thin flexing sections.

Tags