Govee Permanent Outdoor Light Installation Spacing Jig (1-4 Inches)

Govee Permanent Outdoor Lights – Installation Spacing Jig

I designed this simple 3D-printable jig to make installing Govee Permanent Outdoor Lights easier and more consistent.

The jig allows you to position each light at a fixed distance from the wall without repeatedly measuring with a tape measure. Simply place the spacer against the wall, align the light, and attach it using your preferred mounting method.

Included Sizes

• 1 inch (25.4 mm)

• 2 inches (50.8 mm)

• 3 inches (76.2 mm)

• 4 inches (101.6 mm)

Why I Made It

While installing permanent outdoor lights on my house, I wanted an easy way to maintain a consistent distance from the wall. I tested both 2-inch and 3-inch spacing and preferred the light pattern produced at 3 inches.

I designed and 3D-printed this jig to speed up the process. It worked extremely well and made installing the remaining lights significantly easier.

How to Use

1. Choose your preferred spacing and print the corresponding jig.

2. Place the jig against the wall or trim where you're installing the lights.

3. Position the light using the jig as a guide.

4. Attach the light and remove the jig.

5. Repeat along the roofline for consistent spacing.

Printing Notes

• Print in a material suitable for a handheld installation tool.

• No magnets or additional hardware required.

• Check the fit and reference surfaces before beginning installation.

• A key-ring attachment point is included for securing the jig with a suitable tool tether.

Note: This is an independently designed installation aid and is not an official Govee product. Compatibility with all Govee lighting models has not been verified.

Hope this saves you some time on your installation!