1 / 8
HDD Adapter 3.5in to two 2.5in Hard Drives — image 1
1 / 8

HDD Adapter 3.5in to two 2.5in Hard Drives

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Adapter to convert a single 3.5in HDD slot into two 2.5in slots

Rating
0 / 5
Likes
1
Downloads
9
Makes
0
Views
43
Reviews
0

Updated at source:

Model information

Category
Computers
License
Creative Commons — Attribution

Details

HDD adapter that takes a standard 3.5 inch hard drive slot and turns it into two 2.5 inch hard drive slots. 

The main body of the adapter has the exact size as a typical 3.5 inch HDD with side wall screw holes in the same locations as a drive would, which means it slides into a 3.5 inch HDD slot into a computer case. There are also holes to allow a small screwdriver to pass through the side wall to screw in each 2.5 inch HDD.

The 2.5 inch drive slots are made to save material and also allow some airflow on the drives compared to a full 4 wall slot. The slot tolerance is enough for the drive to slide in with ease and hold it in place well but it's recommended to use screws.

The model itself is made to be printed standing with no supports with the connector side facing up. The slope angle for the wall that would have needed supports is set at 35 degrees so most printers won't have any issues. 

Printing & Assembly

Global print settings:

  • Sparse infill density: 15%

  • Wall loops: 3

  • Brim type: outer brim only

  • Brim width: 10mm

This adapter relies on M3 threaded inserts (I used M3x4 with a 4.2mm OD) for the main body screw holes and therefore it is advised to use cylinder modifiers with 100% infill around the screw holes to give the insert solid material to melt into. Like this:

Personally the print took 3h30 and used ~95g of filament. 

Tips

The pictured model has been printed using black Anycubic PLA+ on the Anycubic Kobra 4. If you plan on running this in a case with a poor airflow or a high wattage GPU consider using a different material like PETG in the event that the case temperature reaches the softening point of PLA. I personally used it in a NAS build with plenty of air flow and a cheap "bare minimum for display output" type GPU so case temperature maxes out around 40C even under load.

The easiest method to screw in the 2.5 inch drives is to push a drive into position and then align a screw with tweezers in the space between the main body wall and the slot's screw hole, then get a small screwdriver through the main body wall hole to screw it in. I guess you can also just drop a screw in and hope it lines up but tweezers make this much easier. The slot wall is 3mm thick so you need at least 5mm long M3 screws to reach the drive threads.

FreeCAD project file has been included for anyone wanting to make modifications. The project does use variables but I'm still a noob when it comes to CAD so be careful when playing with values, I can't guarantee that nothing will break doing so.

Some potential improvements include:

  • Skeletonized body to improve airflow further and reduce the amount of material needed to print as the current model is way stronger than it needs to be,

  • Bottom screw holes for the main body so that it fits in case slots that are screwed from the bottom instead of the sides.

Tags