1 / 1
Portable RGB Animation Display – 16×16 WS2812B — image 1

Portable RGB Animation Display – 16×16 WS2812B

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A battery-powered 16×16 WS2812B LED matrix display: an ESP32 cycles plasma, fire, comet and ripple animations.

Rating
0 / 5
Likes
0
Downloads
0
Makes
0
Views
9
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution

A battery-powered display for a 16 × 16 WS2812B LED matrix. An ESP32 DevKit v1 cycles through four animations, plasma, fire, comet and ripple, switching every 9 seconds. The printed front turns the 256 LEDs into a grid of square pixels.

It runs from a 2500 mAh LiPo through a PowerBoost 1000C, which also charges the battery over USB while the display keeps running. The firmware caps brightness and limits the matrix to 850 mA, keeping it within the PowerBoost's 1 A.

Parts

  • ESP32 DevKit v1

  • WS2812B 16 × 16 RGB LED matrix (256 px, serpentine, GRB)

  • 3.7 V 2500 mAh LiPo

  • PowerBoost 1000C

  • 330 Ω resistor (data line)

  • 1000 µF 10 V electrolytic capacitor

Printing

Three parts, sliced separately in OrcaSlicer 2.4.2 for a Bambu Lab P1S (0.4 mm nozzle, 0.20 mm Standard, Bambu PLA Basic, auto-orient, no supports, 20% infill). All three slice cleanly.

  • ledmatrixdiyv1.1.stl: 166.4 × 177.9 × 95.3 mm, about 3 h 47 min

  • ledmatrixBACKv1.1.stl: 166.4 × 52.1 × 81.3 mm, about 2 h 18 min

  • ledmatrixinfillv1.1.stl: 159.6 × 159.6 × 8.2 mm, about 1 h 46 min

Assembly

  1. Find the matrix's data-in end: the tail of the arrow on its back. Use only that end's 5V, GND and DIN.

  2. Plug the LiPo into the PowerBoost. The matrix and the ESP32's 5V/VIN pin both take 5 V from the PowerBoost output; never wire the battery to them directly.

  3. Put the 1000 µF capacitor across the matrix's 5V and GND input, stripe to GND, and tie every ground together.

  4. Run GPIO4 through the 330 Ω resistor to the matrix's DIN pad.

  5. Flip the PowerBoost's switch on (or connect the battery) and the animations start. To charge, plug USB into the PowerBoost.

The guide covers the electronics; it doesn't cover fitting them into the printed parts.

Full guide with wiring and firmware: https://www.schematik.io/projects/portable-rgb-animation-display-g2sr

Firmware and wiring guide generated with Schematik, our AI hardware tool; the enclosure was modelled by hand.

Tags