Modern Minimalist Desk Clock - Compatible with Bambu Labs Clock Components Kit 011
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A minimalistic desk clock powered by an ordinary quartz mechanism that makes for an excellent gift.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 1
- Makes
- 0
- Views
- 7
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
To build this project with, you will need
One: HR-1688 quartz wall clock replacement mechanism (This model is compatible with the Bambu Labs Clock Components Kit 011
Glue of your choice (I highly recommend CA/super glue)
Tape of your choice
Four: M3 heat-set inserts of any length less than 10mm(Optional, see below)
Four: M3 screws
One: Print_Face or Laser_Face
One: Clock_Body or Clock_BodyNOInsert (Both require very small supports)
One: Clock_Cover (Due to the distribution of weight of the model, it is highly recommended that you print this with 100% infill to prevent the clock from easily tipping over).
Twelve Hour_Ticks (Optional)
All prints are in their correct orientation by default, so you won't need to change their position or rotate them in the slicer. Only the Clock_Body and Clock_BodyNOinsert models require very small supports along the bottom two rails that support the face of the clock. For the Print_Face I highly recommend lowering your initial layer speed in order to prevent the holes for the Hour_Ticks from lifting off and ruining your first layer.
If you wish to build the clock without any heat-set inserts, print the Clock_BodyNOInsert file. If you wish to laser cut the face, use a material with a thickness of 2.5mm or 3/32". Be sure to download the Laser_Face.dxf file instead of the Laser_Face.stl file, which is only there to show what the final product will look like.
If you opted to include the Hour_Ticks first insert all twelve into whichever Face that you made. Then tape the Hour_Ticks to the face and flip the face such that it is facing downwards with the space for the clock mechanism facing up and the Hour_Ticks are resting on the surface of your workspace. Then, glue the Hour_Ticks in from the back.
Once you finish this step/if you did not opt for the Hour_Ticks, insert the clock mechanism into the slot in the back of the Print_Face and put the battery in. If you opted for the Laser_Face, then the side does not matter. Using the washer and nut that came with your quartz mechanism, bolt the quartz mechanism to the face. Then, fit the Face into whichever Clock_Body you made so that it makes contact along the two vertical rails. If it does not fit with just friction, carefully glue it in from the inside of the clock to avoid frosting with CA glues.
If you opted to use heat-set inserts, carefully place each one in the holes located on the back of the Clock_Body, making sure that they are parallel with the rear side of the clock and not the front side.
Once you finish this step/if you did not opt for the heat-set inserts, screw the Clock_Cover on with the four M3 screws. Note that it is not a perfect square and can only be screwed on one way
Your quartz mechanism likely came with a selection of hour, minute, and second hands to choose from. Select the ones you like (You may have to cut them down) and insert them into their respective shafts on the quartz mechanism. You can also stick some rubber feet to the bottom.
