1 / 9
Single Rail Triple Hook Spool Holder (19x11 mm slotted wall rail) — image 1
1 / 9

Single Rail Triple Hook Spool Holder (19x11 mm slotted wall rail)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Tool-free spool holder for 19x11 mm slotted wall/shelf rails. 3 hooks, solid 26 mm arm, fits 1 kg spools.

Rating
0 / 5
Likes
0
Downloads
0
Makes
0
Views
1
Reviews
0

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution — Noncommercial

A clean, tool-free way to hang a filament spool right next to your printer: the holder simply drops into a standard slotted wall / shelf rail – no screws, no drilling, no hardware.

How it works

• Three hooks (50 mm pitch) go through the rail slots and catch behind the front wall of the rail.

• Two side jaws wrap around the rail, so the holder can't twist or wobble, even with a full spool.

• Slide it down and it locks itself in place under the spool's weight. Lift it up to remove or move it.

Rail compatibility – please measure yours first!

• Rail width: 19 mm (the channel is 19.4 mm, 0.2 mm clearance per side)

• Rail depth: 11 mm, open back (jaws are 10.8 mm deep, hooks 9.0 mm – they won't touch the wall)

• Slots: at least 3.2 mm wide and 18 mm long, 50 mm or 25 mm pitch

• Rail front wall: up to ~2.5 mm thick (the hook catch is 3 mm wide and 7.1 mm deep)

Spool arm

• Solid Ø26 mm arm, ~84 mm usable length, Ø38 mm end cap

• Fits standard 1 kg spools (hub hole ≥ 30 mm)

Print settings (tested on an Anycubic Kobra S1, PLA)

• Orientation: as in the 3MF – standing on the jaw edges, arm pointing up. This way the hooks and jaws are printed in the layer plane, which makes the load-bearing parts as strong as possible. Please don't reorient it.

• Layer height 0.16 mm, 6 walls, 40% gyroid infill, 5 bottom layers

• Supports: only under the 3 hooks (they start ~1.8 mm above the bed). They are already painted in the 3MF (normal/manual supports) – no other supports needed.

• Brim: 5 mm outer brim with 0.15 mm object gap – it merges with the support pads into a solid base and peels off easily.

• PLA at 220 °C for better layer bonding; PETG works too.

• About 70 g of filament.

After printing

• Remove the small support pads under the hooks and lightly deburr the first-layer edges of the hooks and jaws – these go into the rail.

• Hook it in, push it down, hang your spool. Done!

The 3MF contains the full Anycubic Kobra S1 0.4 project (Anycubic Slicer Next / OrcaSlicer based), including the painted supports and the seam placed on the hidden underside of the arm.

Tags