Single Rail Triple Hook Spool Holder (19x11 mm slotted wall rail)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Tool-free spool holder for 19x11 mm slotted wall/shelf rails. 3 hooks, solid 26 mm arm, fits 1 kg spools.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 1
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
A clean, tool-free way to hang a filament spool right next to your printer: the holder simply drops into a standard slotted wall / shelf rail – no screws, no drilling, no hardware.
How it works
• Three hooks (50 mm pitch) go through the rail slots and catch behind the front wall of the rail.
• Two side jaws wrap around the rail, so the holder can't twist or wobble, even with a full spool.
• Slide it down and it locks itself in place under the spool's weight. Lift it up to remove or move it.
Rail compatibility – please measure yours first!
• Rail width: 19 mm (the channel is 19.4 mm, 0.2 mm clearance per side)
• Rail depth: 11 mm, open back (jaws are 10.8 mm deep, hooks 9.0 mm – they won't touch the wall)
• Slots: at least 3.2 mm wide and 18 mm long, 50 mm or 25 mm pitch
• Rail front wall: up to ~2.5 mm thick (the hook catch is 3 mm wide and 7.1 mm deep)
Spool arm
• Solid Ø26 mm arm, ~84 mm usable length, Ø38 mm end cap
• Fits standard 1 kg spools (hub hole ≥ 30 mm)
Print settings (tested on an Anycubic Kobra S1, PLA)
• Orientation: as in the 3MF – standing on the jaw edges, arm pointing up. This way the hooks and jaws are printed in the layer plane, which makes the load-bearing parts as strong as possible. Please don't reorient it.
• Layer height 0.16 mm, 6 walls, 40% gyroid infill, 5 bottom layers
• Supports: only under the 3 hooks (they start ~1.8 mm above the bed). They are already painted in the 3MF (normal/manual supports) – no other supports needed.
• Brim: 5 mm outer brim with 0.15 mm object gap – it merges with the support pads into a solid base and peels off easily.
• PLA at 220 °C for better layer bonding; PETG works too.
• About 70 g of filament.
After printing
• Remove the small support pads under the hooks and lightly deburr the first-layer edges of the hooks and jaws – these go into the rail.
• Hook it in, push it down, hang your spool. Done!
The 3MF contains the full Anycubic Kobra S1 0.4 project (Anycubic Slicer Next / OrcaSlicer based), including the painted supports and the seam placed on the hidden underside of the arm.
