1 / 3
Handle drilling jig for Howdens 500 mm standard drawer units: 128 mm hole centres, self-centring — image 1
1 / 3

Handle drilling jig for Howdens 500 mm standard drawer units: 128 mm hole centres, self-centring

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Hooks over the top and both sides of a drawer front, so every handle lands in the same place with no measuring.

Rating
0 / 5
Likes
0
Downloads
0
Makes
0
Views
3
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Noncommercial — Share Alike

A drilling jig for fitting bar handles to Howdens drawer fronts. It hooks over the top and both side edges of the front, so it centres itself, and guides a 5 mm drill through two bores.

  • Fits the drawer fronts on a Howdens 500 mm standard drawer unit.

  • Handles with holes 128 mm apart, centred 79.5 mm below the top edge.

  • For other sizes, change the values at the top of handle_jig.scad.

Print: the centre, both arms and two splice plates. Slide the dovetails together and screw a splice plate over each joint with four 3 × 12 mm screws.

Use: pull the drawer out about 30 mm, hook the jig over the front with TOP upright, and drill through both bores.

Print settings

PETG, 0.20 mm layers, no supports, outer face down. All five pieces fit on one 256 mm plate: about 3 h 30 and 132 g.

Found this useful? You can buy me a coffee or sponsor me on GitHub.

Tags