Astrolle, Starry Sky Cylinder Lamp
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Stars and round holes cut through a cylinder lamp light up from inside. Swap the Diffuser; twist lock, no supports.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 6
- Makes
- 0
- Views
- 26
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bedroom
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Astrolle
A cylinder full of stars. Round holes of every size and a few four-point stars are cut through the wall and over the top, so with the light on, the lamp turns into a small starry sky.
The round sibling of Astrelle. Calm and soft on a bedside table, in a child's room, a reading corner or on a desk at the end of the day. Runs on a standard 60 mm USB LED light kit and twists and clips together without glue or screws.
Swap the glow
The colour comes from the Diffuser, a thin insert printed in Spiral vase. Print a few in different colours: pull the Sleeve gently off the Lock ring, swap the Diffuser and clip the Sleeve back on.
A dark or silky Sleeve keeps the stars crisp: the blue lamp in the photos has a gold Diffuser. A light, bright Sleeve also glows softly through its walls: the pink lamp has a white Diffuser.
Two sizes
You will need
One 60 mm LED light kit, USB, 5 V. Nothing else.
Printing
Both sizes have two plates:
Base and Sleeve: the Base, the Lock ring and the Sleeve.
Diffuser components: the Diffuser and the Diffuser cap, already set to Spiral vase on the plate.
The settings are already in the files. Printing from your own profile? Use these:
Wall generator: Arachne, for every part.
Diffuser and Diffuser cap: Spiral vase.
Sleeve: 3 walls, wall order outer/inner.
Base and Lock ring: concentric top surface, 7 % gyroid infill.
Supports: off.
Print the Diffuser in a light or translucent filament, so the glow comes through.
Assembly
Drop the LED light into the Base and lead the cable out through the slot.
Twist the Lock ring onto the Base until it stops.
Lay the Diffuser cap on the Lock ring and push the Diffuser onto it.
Clip the Sleeve onto the Lock ring, over the edge that runs around it.
Parts
Base, Lock ring, Sleeve, Diffuser and Diffuser cap.