Drawer Roll Dispensers for Costco Plastic Wrap, Foil & Parchment (no supports, optional lid)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Drawer dispensers for Costco. The roll sits on screw-in caps, the wrap one reuses the box's slide cutter. No supports.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 3
- Makes
- 0
- Views
- 26
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Ditch the soggy cardboard box.
The boxes Costco plastic wrap, foil and parchment come in fall apart long before the roll runs out. The lid tears, the cutter strip comes loose and the roll rattles around the drawer. These dispensers replace the box. You print one once and refill it forever.
AI was used to help with the Marketing material and the PDF document.
What it does
- The roll can't fall out. A screw cap at each end goes into the cardboard core and holds the roll, so it spins freely and stays put when you toss the dispenser in a drawer.
- Reuses the slide cutter. The cutter rail from the Kirkland wrap box sticks onto the front lip, the same way it sat on the box.
- Saw teeth for foil and parchment. Fine teeth for foil, coarser ones for parchment.
- No supports, no glue. The two halves slide together and three small keys click in to lock them.
- Optional lid. It snaps onto hinges at the back and clicks shut at both ends.
- Honeycomb or solid walls. Honeycomb shows how much roll is left.
Putting it together
There is a TESTS file that lets you first print all the connections to test printer tolerance!Ditch the soggy cardboard box.

1. Slide the two halves together until the three little windows line up.
2. Push a key into each window until it clicks. The keys only go in one way round: look along the dispenser and you should see the key's two prongs. There's a picture of this in the gallery and in the PDF.
3. Drop the roll in so the sheet comes off the top, toward you, and screw a cap into each end.
4. Wrap only: peel the slide-cutter rail off the box and press it into the channel on the front lip.
5. Lid: slide its two halves together until they click, push it down onto the hinge rods, then close it until both ends click.
For more info the PDF in the files shows every step with photos.
Printing
No supports. Print every part the way it sits in its file: halves standing on their threaded end, caps on their knob, keys flat, lid halves top down.
PLA or PETG, 0.2 mm layers, 2 walls, 15 % infill.
A 5 mm brim helps the tall halves stay put.
Fits a 220 × 220 × 250 mm printer. The tallest part is 222 mm. The parchment left lid half is 219.5 mm long, so turn the skirt and brim off for that one.
Not affiliated with Costco, Kirkland Signature or Alcan. The names only say which rolls it fits.
