Romex Wire Stacker for Studs & Joists (BX/MC too)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Holds up to 6 Romex, BX or MC cables on the side of a stud or joist. Mounts with #6 drywall screws.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 2
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Standard Digital File License
Holds up to 6 cables on the side of a 2x4 stud or a ceiling joist, and mounts with the #6 x 1-5/8 in. drywall screws you already carry.
Front slot: flat Romex (14/2, 12/2, 14/3, 12/3) on edge, 3 deep.
Back slot: BX or MC (14/2 to 12/3), round 12/3, or any Romex, 3 deep. BX and Romex can share it.
Snaps in, stays put. The tab tips nearly touch, so each cable clicks past them and stays until you pull it out by hand. Nothing to press.
Stays in the safe zone: with the straight edge flush with the stud's face, the cables sit 1.32 to 2.18 in. back, inside the middle 1 in. of a 2x4 (the 1-1/4 in. nail zone on both sides stays clear).
3 angled screw seats driven from the room side, facing the front of the stud: use the center seat alone or the 2 end seats. 2 small grip points on the back keep it from twisting.
Works on wall studs and ceiling joists. Last cable in comes out first.
Print: PETG, default 0.20 mm profile, no supports. The file is already standing on end; the whole part is one straight profile, so nothing prints in mid-air. A small groove on the straight edge gives the layer seam a place to sit.
Doesn't fit: 10 gauge BX.
Not a UL-listed product. Check with your local inspector before using it on a job.