Mooer GWF4 footswitch holder for HSW
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Vertical cup for the Mooer GWF4 wireless footswitch, switch face out, 2 pegs, no supports.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 1
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution
Holds the Mooer GWF4 wireless footswitch (224 x 40 x 26 mm body) standing on its short end, switch face out.
Cup inside 40.8 x 26.8 x 45 mm (0.4 mm gap per side), back plate 4 mm, walls 2.5 mm, floor 3 mm with a window.
The front U-slot clears the lowest footswitch, so it isn't pressed; the side parts of the front wall stop the device tipping forward.
2 hex pegs in one column: the bottom one flat on the bed, the top one with a 45 degree ramp underneath.
Not print-tested yet.
Printing: upright, back plate vertical, pegs horizontal, as the files are oriented. No supports. Layer 0.2 mm, 3-4 perimeters, 20% infill, PETG or PLA.
Designed for the standard Honeycomb Storage Wall panel by RostaP. Files: STL, 3MF and STEP.