Park Tool MB-1 Parts Bowl Holder for PCS-10.3 Repair Stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Clamp-on holder for the Park Tool MB-1 magnetic parts bowl. Fits the teardrop tube of the PCS-10.3 and compensates the 1
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 1
- Makes
- 0
- Views
- 9
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Holder for the Park Tool MB-1 magnetic parts bowl that clamps onto the teardrop-shaped tube of the Park Tool PCS-10.3 repair stand. The bowl sits to the side of the stand instead of in front, so it stays out of the way while you work.
FEATURES
- Two-piece clamp shaped to the teardrop profile of the PCS-10.3 tube (measured: 36.7 × 43 mm)
- Compensates the ~12° lean of the stand (tube at ~78°), so the bowl sits level
- Bowl seat with 6 crush ribs – the MB-1 foot (Ø 83 mm) clicks in and stays put
- Long bridge so the curved bowl (Ø 150 mm, rim ~158 mm) clears the clamp and the tube
- Hex nut slots from the top – nuts can't spin
- Available in a right and a left version
IMPORTANT
Each arm part has its own counter clamp, because the clamp is tilted:
- MB1-Holder_ArmPart_right + MB1-Holder_CounterClamp_right
- MB1-Holder_ArmPart_left + MB1-Holder_CounterClamp_left
Right and left parts do NOT fit together. The 3MF files contain the matching pair.
HARDWARE
- 2× M5×20 socket head cap screw (DIN 912)
- 2× M5 hex nut
- Optional: thin strip of old inner tube (0.5–1 mm) between clamp and tube to protect the paint and prevent slipping
PRINT SETTINGS (tested on Prusa MK4S)
- Material: PETG (PLA may creep under clamping pressure and in a warm workshop)
- Profile: 0.20 mm STRUCTURAL
- Perimeters: 4
- Top / bottom layers: 5 / 4
- Infill: 20–25 % gyroid
- Supports: none
- Orientation: as provided, flat side on the bed
- Brim: not needed on textured sheet; add 3–5 mm if the counter clamp lifts
ASSEMBLY
1. Drop the nuts into the hex slots on top of the arm part.
2. Place both halves around the tube (optional inner tube strip as liner).
3. Insert the screws from the counter clamp side and tighten until the clamp is snug – no need to force it.
4. Press the MB-1 into the seat.
HOW THIS WAS MADE (AI-ASSISTED)
This model was created with AI assistance. I described the requirements and the parts, and the AI (Claude by Anthropic) generated the parametric geometry. I measured the stand and the bowl myself, printed test rings to check the tube fit, mounted the prototype and fed the results back: straighter tube flanks, longer bridge for the curved bowl, 12° tilt compensation, closed and reinforced arm, crush ribs for the bowl. The final version was printed and tested on my own PCS-10.3.