Centerlock Self-Centering Vise v2: Wider Carriages (parts update)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Only the parts that changed are in this folder. Everything else (body, screw, jaws, wheels, clamp, TPU pads) is unchange
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 1
- Makes
- 0
- Views
- 8
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
V1 With rest of files avalible here:
Why
A test print of v1 showed the threaded carriage that sits on top of the body was a little too tight on the rails. All other fits (thread, jaw slot, handwheel) were reported good.
Changed files
File | Change |
|---|---|
| Side gap to the body 0.3 -> 0.6 mm, rib flank gap 0.3 -> 0.55 mm, gap over the deck 0.3 -> 0.4 mm. Carriage is 67.2 mm wide (was 66.6). Thread, jaw slot and overall shape unchanged |
| Rail test pair regenerated with the same wider fit (print first to check, 16 mm long each) |
| Updated source: |
Print the same way as v1: carriage-a on the handwheel side, carriage-b on the knob side, 4 walls, 25 % infill, no supports.
Checks
Both carriages watertight, 20 x 67.2 x 42.9 mm, flat print orientation, no supports
Assembled with the v1 body and screw at three jaw positions (2.7, 34.7, 74.7 mm gap): no overlap with body or screw
Rail coupon pair: no overlap
Not yet re-printed. Still too tight or loose? Change
LEG_CL/RIB_CLby 0.1 and re-run
Shout out to @Agit68_226454 for bringing this issue to my attention!