Centerlock Self-Centering Vise v2: Wider Carriages (parts update)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Only the parts that changed are in this folder. Everything else (body, screw, jaws, wheels, clamp, TPU pads) is unchange
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 8
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
V1 With rest of files avalible here:
Why
A test print of v1 showed the threaded carriage that sits on top of the body was a little too tight on the rails. All other fits (thread, jaw slot, handwheel) were reported good.
Changed files
File | Change |
|---|---|
| Side gap to the body 0.3 -> 0.6 mm, rib flank gap 0.3 -> 0.55 mm, gap over the deck 0.3 -> 0.4 mm. Carriage is 67.2 mm wide (was 66.6). Thread, jaw slot and overall shape unchanged |
| Rail test pair regenerated with the same wider fit (print first to check, 16 mm long each) |
| Updated source: |
Print the same way as v1: carriage-a on the handwheel side, carriage-b on the knob side, 4 walls, 25 % infill, no supports.
Checks
Both carriages watertight, 20 x 67.2 x 42.9 mm, flat print orientation, no supports
Assembled with the v1 body and screw at three jaw positions (2.7, 34.7, 74.7 mm gap): no overlap with body or screw
Rail coupon pair: no overlap
Not yet re-printed. Still too tight or loose? Change
LEG_CL/RIB_CLby 0.1 and re-run
Shout out to @Agit68_226454 for bringing this issue to my attention!