Sonelle, Wave Slots Cylinder Lamp
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Pointed slots rise and fall like a wave around this cylinder lamp. Swap the glow, twist it together, no supports.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 1
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bedroom
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Sonelle
Pointed slots run down this cylinder in columns, and their lengths rise and fall from one column to the next like a wave. No slot runs from top to bottom: short bars break every column. On the top, the slots fan out from the centre and run over the edge. The slots are cut clean through the wall, so with the light on, only the slots glow.
For a desk, a shelf or a bedside table. Runs on a 60 mm USB LED light kit and twists and clips together without glue or screws.
Swap the glow

The colour comes from the Diffuser, a thin insert printed in Spiral vase. Print a few in different colours: pull the Sleeve gently off the Lock ring, swap the Diffuser and clip the Sleeve back on.
The lamp in the photos has a pink Sleeve, shown with two Diffusers: a blue one for the cyan glow and a green one for the green glow.
One size

You will need
One 60 mm USB LED light kit (USB, 5 V).
Printing
Two plates:
Base and Sleeve: the Base, the Lock ring and the Sleeve.
Diffuser - Vase mode: the Diffuser, already set to Spiral vase on the plate.
The settings are already in the files. Printing from your own profile? Use these:
Wall generator: Arachne, for every part.
Diffuser: Spiral vase.
Sleeve: 3 walls, wall order outer/inner.
Base and Lock ring: concentric top surface, 7 % gyroid infill.
Supports: off.
Print the Diffuser in a light or translucent filament, so the glow comes through.
Assembly

Drop the LED light into the Base and lead the cable out through the slot.
Twist the Lock ring onto the Base until it stops.
Push the Diffuser onto the Lock ring.
Clip the Sleeve onto the Lock ring, over the edge that runs around it.
Parts

Base, Lock ring, Sleeve and Diffuser.
