TrackIR TrackClip PRO Battery Compartment Headphones Clip
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
With the addition of; 1) 2 x CR2016 3v Batteries, 2) A paperclip (or 1.25mm wire) for battery contacts 3) Micro toggle…
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 60
- Makes
- 0
- Views
- 1,189
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
With the addition of;
2 x CR2016 3v Batteries,
A paperclip (or 1.25mm wire) for battery contacts
Micro toggle switch
4 x spectacle size screws
you can get rid the USB lead for power and run cableless. (Some additional small lengths of wire might be needed to extend but can be harvested from the USB cable)
It works by removing the "twig" bit and it's extender from the original mount and wiring up through the switch with the original resistor. I designed it for my SteelSeries Arctic 5 headset but should work fine with most.
The Battery Holder part is a modified version of https://www.thingiverse.com/thing:48606 by NotSoSolid by adding channels for the wire/paper clip underneath to allow it to lie flat in the TrackIR compartment.
Print Settings
Printer:
Cetus 3D Mk2
Resolution:
0.15
Infill:
99%
Filament:
Tianse PLA
Black
Notes:
99% Infill gives the clip huge strength and flex.
Category: Electronics