RC brushless motor cable clip / hold down
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple 3 wire cable clip to help with constraining motor wires. Uses a zip tie to secure top and bottom halves.
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 52
- Makes
- 1
- Views
- 701
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
Here is a simple way of organizing and securing 3-wire brushless motor leads on an RC boat, plane, or car. A small zip tie runs through the bottom to secure the two halves in a tight bundle. I used 2mm wide zip ties, but there's a bit of wiggle room if you have wider ones on hand.
This was designed for 12 gauge wires, but i have included the Fusion 360 file if you want to modify for different gauges.
I recommend printing with a 0.4 mm nozzle and 0.15 mm layer heights. PETG worked well for these prints, but I'm sure PLA or ABS would also be fine. Place the parts on the build plate with the outsides facing down. Don't use any supports. The bridging is pretty minimal and shouldn't pose an issue for most printers if you go slow and use a cooling fan.