Slim microphone side mount for yaesu radios
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Perfect for tidying up your "radio stack". Works with Yaesu radios like the FT-100 and FT-7100 and the MH42B microphone
- Rating
- 5 / 5
- Likes
- 33
- Downloads
- 192
- Makes
- 2
- Views
- 845
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
Have got into ham radio communications recently and bought a few radios. I started stacking them but soon i got submerged with wires and microphones. The thing is i didn't know which microphone was for which radio because they use the same model. So i decided to make a side mount for my radios. The part is pretty simple, it's just a plate with a mic mount that is secured by the two screws intended for the mounting bracket on the side of the radio.
It prints fine without any supports and with 15% infill on my PrusaMini+ with Prusament PLA.
There might be some strings on the top bridge but a good set of cutting pliers are here to help.
It prints very fast too, only around 20 minutes.
Works with the older Yaesu radios like the FT-100 and the FT-7100. I'm curious to find out with which other models it might work :)
Happy printing and good DX
73s from HB3XYR, Fribourg - Switzerland