Slim microphone side mount for yaesu radios
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Perfect for tidying up your "radio stack". Works with Yaesu radios like the FT-100 and FT-7100 and the MH42B microphone
- Ocena
- 5 / 5
- Polubienia
- 33
- Pobrania
- 192
- Wydruki
- 2
- Wyświetlenia
- 845
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Have got into ham radio communications recently and bought a few radios. I started stacking them but soon i got submerged with wires and microphones. The thing is i didn't know which microphone was for which radio because they use the same model. So i decided to make a side mount for my radios. The part is pretty simple, it's just a plate with a mic mount that is secured by the two screws intended for the mounting bracket on the side of the radio.
It prints fine without any supports and with 15% infill on my PrusaMini+ with Prusament PLA.
There might be some strings on the top bridge but a good set of cutting pliers are here to help.
It prints very fast too, only around 20 minutes.
Works with the older Yaesu radios like the FT-100 and the FT-7100. I'm curious to find out with which other models it might work :)
Happy printing and good DX
73s from HB3XYR, Fribourg - Switzerland