Speedlight and Umbrella Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A speedlight and umbrella holder that will work with any 15mm light stand.
- Rating
- 0 / 5
- Likes
- 23
- Downloads
- 134
- Makes
- 1
- Views
- 1,030
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I needed a speedlight & umbrella mount, and the other two that was available to print had the limitation of being set in a horizontal position that would not work for the photoshoot that I needed to do. So I redesigned using other components to allow the vertical rotation of the umbrella and flash.
The Umbrella mount and Flash shoe need to be glued together.
Printing instructions (All files are correctly orientated for printing):
Light stand mount: Print upright with a 25% infill.
Umbrella Holder: Print upside down with a 25% infill.
Hot shoe Mount: Print with the flash insert opening to the top with a 100% infill.
GoPro Screw: Print Upright with 25% infill.
Additional requirements:
1x M5 30mm bolt
1x M5 nut
2x M4 10mm bolts
Assembly is straight forward, but do note that everything fits very snug so some gentle persuasion might be needed to get everything fitting together for the first time.
The M4 bolts that hold the umbrella into place and locks the mount onto the light stand is design in such a way that the first time the bolt is inserted it taps the hole for a snug fit.