DJI Mini 3 RC / DJI Mini 4 RC2 "Bike Adapter"
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Adapts the RC and RC2 controller of the DJI Mini 3 Pro and DJI Mini 4 Pro to a bicycle
- Rating
- 4.75 / 5
- Likes
- 144
- Downloads
- 738
- Makes
- 6
- Views
- 8,014
- Reviews
- 8
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
Adapts the **RC controller** of the **Mavic Mini 3 Pro** to a bicycle.
Adapts the **RC2 controller** of the **Mavic Mini 4 Pro** to a bicycle.
Use at your own risk! I assume no liability for damages.
The idea is to use an existing adapter on your bike to adapt this bracket to.
e.g. if you own a Garmin Bike computer, you can use the adapter that came with your Garmin computer and adapt this DJI RC bracket to it.
In case you haven't got anything, just buy a GoPro Bike bracket online or find one to 3D-print.
As for now, those adapters are supported:
- GoPro
- Garmin or
- Wahoo
- Smartphone holder (separate Download, not included in "allparts"-stl File)
Make sure, the adapter is properly mounted on the bike, e.g. Garmin adapters come with rubber O-rings that are good enough to hold a bike computer, but may be not the RC (it's up to you to decide).
I own a Wahoo bike computer and use this adapter, it's quick and easy to mount and remove.
There is a hole in the frontplate, you may use it to secure it in addition with a cord to prevent the RC from falling to the ground, in case anyhing breaks (I don't think it is necessary).
For damping, I added a short strip of window insulation tape as shown in pictures.
Addional parts
- 4x M4 hex nuts
- 2x M4x10 or M4x12 countersunk screws
- 2x M4x18 cup square screws (I bought 30mm ones from OBI and shortened them, see attached pictures)
- two short straps of window insulation tape
Printing
- GoPro, Garmin and Wahoo Adapters must be printed with PETG and 100% infill.
- Other parts should also be printed with PETG.
- I used a Prusa MK3S+ printer and sliced it with standard infill settings (15% fill density)
- RC2 adapter may look a bit better when printed with supports, I for myself printed it without supports (it need just a little bit of cleaning-up)