Cable Cover / Integrated Rail for PrusaBox by PrinterBox

Cable cover with integrated rail and magnets of course. Now you can mount whatever you want and you can change the vertical position in a blink of an eye. 

Instructions

• Print with supports (Important! Take a look at .gcode). I recommend using the “Intelligent mode” of prusa slicer.
• Print as many gliders and holders you need
  
  
   
• Remove the old rail
• If you have the frame for the thermometer installed (https://help.printer-box.com/3d-printer-enclosure-thermometer/), remove the clamp.
  
  

• Install the magnet holder (you'll need a longer screw: M3 x 20).
  
  

• Make sure the magnet poles of the holder and the glider are installed correctly, + and - must be facing each other.
  
   

For owners of the Logitech C270 camera:
 

• If you use a Logitech C270, download and print the magnetic holder I've designed:
  
  https://www.printables.com/de/model/125937-magnetic-camera-holder-for-logitech-c270
  
  
   
• You will only have to print the marked part:
  
  
  

For owners of the Logitech C920 camera:

• Download mount: https://www.thingiverse.com/thing:3013280/files
• Download my C920 magnet holder ("C920_Magnet_Mount.stl")
  
  
  
   
• Note: This is a quick & dirty design that has not been tested and was created only on the basis of the .stl source on thingverse (simply because I don't own a c920 ). I am not sure wether the magnet will be strong enough to hold this heavy camera (but I guess this should do, as long as you use neodym magnets).

For all other cameras

• If you have a different camera installed, you probably have to design your own magnet holder.

Installation

• Mount all magnets. Use superglue to fix them, if necessary.
• Insert the glider into the rail. You will notice a small angle downwards. But this is intentional. Otherwise it would not be possible to provide enough space to move the glider along the rail. This also makes it a bit shaky when you slide/move it. Remember: The system is not meant to be rock solid, but functional and clean looking. 
• To move the glider, simply pull it, change the position and push it back in. 

You need:

8   8 x 3 magnets for the cover
1   8 x 3 magnet for the glider
1   8 x 3 magnet for the holder 
1   8 x 3 magnet for the Logitech c270 holder
1   8 x 4 or 8 x 3  magnet for the Logitech c920 holder
1  M3 x 20 screw for the thermometer holder

Note

Check out my magnetic probe holder, that will perfectly fit to this print. 

https://www.printables.com/de/model/125317-magnetic-holder-for-temperature-sensors-probes