Yarn Caddy #2
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€2.08 – €2.55 net (excluding VAT)
For file: lid v10_0.2mm_20%_2p_PLA_17.5141m_MK3S_2h53m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €2.32 excluding VAT (range midpoint).
- Weight reported by the author
- 17 g
- Print time reported by the author
- 2.89 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Another yarn caddy (yarn bowl plus) for knitting or crocheting. This one is bigger.
- Rating
- 0 / 5
- Likes
- 20
- Downloads
- 17
- Makes
- 1
- Views
- 616
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a variation of Yarn Caddy #1. It is made with an even bigger jug for pork rinds. The jug is about 10" deep, 9" diameter, and opening about 6". It will hold a full 16oz skein or several smaller ones.
This has two cutouts. With the extra cutout you could easily work a multi-yarn project. The cutouts will accept up to size 19 needles.
The jug is not threaded, so I had to figure out to attach the lid. It has two slightly offset rings, so I went with blocks that wedge between them. You line it up with the top ring opening, slide it on, then turn until it snaps down into the second ring, and turn a little more to get a snug fit.
My wife sewed a cover for this one also - complete with a strap and drawstring. I made Matsugawa's Decorative Cherry Blossom (https://www.thingiverse.com/thing:2734083) that she sewed on.
It prints with no support. I used PLA+ for this one. But I used a piece of ABS filament for a stronger hinge.