BackSplash – Sharpie holder

Here’s what I learnt making this:

1st print failed?

• So the magnet I choose was about 10mm x 1.5mm, so what went wrong? The tolerance in the print!
• (The below image is flat because of printer problem and g-code mistake, so I just removed it before it even finished)

So giving tolerance value about 0.25-0.5 mm is Worth it!

2nd print failed?

• While increasing the tolerance, the value increased about 1.7mm thinking it was 0.7mm lol!
• I made a small bridge so that magnet won't  pop out, but it dint work, and magnet didn't fit in the slot

- I pause the print and checked if magnet fits well, but there was huge gap in the insert, so just removed the print! (just saved the material & time)

3rd print failed?

- Nope

The print went well with perfect fit of the magnet without any Problem!

Which is the right print file for you (Recommended):

I have included 3 files as you can see the below magnet slot designs.

1. Capsule insert: The magnet can be dropped inside so the magnet doesn’t come out.

2. Circle insert: I had a 10mm x 1.5mm magnet, so the magnet was perfect snap fit.

3. No insert: if you have any magnet, you can just get the dimension and make circle insert as per your dimensions.

4. Sharpie holder:

Adjust the holder according to your own sharpie if needed and just combine it with the base.

Dimensions:

• 74mm x 74mm x 23mm

Print Setup:

• Nozzle diameter  - 0.3mm
• Layer height         - 0.2mm
• Infill                       - 20% - 30%
• Supports               - Not Required

Print Time:

• 1hr 10 mins (weigh - 12g)

Happy Printing!