Manta MK2 CR Touch Mount Center Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
this is for the manta mk2 ender v1/v2 system to allow the cr touch to be used as the sensor instead of the bltouch
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 36
- Makes
- 1
- Views
- 385
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Public Domain
When making the bracket try using petg or abs or anything stronger then pla. If you run a hi-temp set up use something that can stand hi-temps
when installing use, the spacer to adjust the CRt at about 3mm above the nozzle. (the spacer is the same one you use to adjust the fans).
When installing use washers', Screws through CRt and bracket then washer then nut
The X/Y Offset I use:
X= -1.8
Y= -37.5
Print Setting:
Layer height 2.0 or 1.6 (I prefer 1.6)
Infill 100% (it doesn't really matter I jus set it up this way)
speed 40mm/s for abs and petg
Note:
You can use the 2mm side of the spacer or even flush the cr to the bed. I wouldn't recommend using the bracket that way but, in the time, I've had this bracket made, spacing it 3 mm above the nozzle is the best option. it will not crash nor give you some funny z offset spacing like -5, -6 mm z-offset