Patio Door Replacement Handle
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement for a broken plastic patio door handle.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 40
- Makes
- 0
- Views
- 294
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution
The door handle broke years ago and I had a piece of painted pine in it's place after buying and returning a few poorly fitting replacements. I got tired of looking at the pine handle and it was a good excuse to buy ASA filament. I used blue Flashforge ASA and it prints beautifully.
It's a simple model with a few slide in place nuts. My handle had two 8-32 screws located 100 mm apart. I used some square nuts I scavenged off something. I resized the model to work with McMaster-Carr part number 94855A216, https://www.mcmaster.com/94855A216/. I also reduced the depth of the screw hole as it was visible on the exterior of the handle.
Printed on back of handle as shown in picture without support. I printed a test sample as the bridging sagged a bit. You can adjust the nut pocket width in FreeCAD by double clicking on Pocket2 and Pocket 3. These are cut to half the nut width starting at the screw center.