1 / 4
Jeep WJ Grand Cherokee Front Bumper Retainer Clip 6505361AA — image 1
1 / 4

Jeep WJ Grand Cherokee Front Bumper Retainer Clip 6505361AA

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Front Bumper Retainer for 2000 WJ Jeep Grand Cherokee

Rating
0 / 5
Likes
9
Downloads
72
Makes
0
Views
1,009
Reviews
0

Updated at source:

Model information

Category
Automotive
License
Creative Commons — Attribution — Noncommercial — Share Alike

This is a front bumper retainer for my 2000 WJ Jeep Grand Cherokee Limited. I'm assuming it is the same for all 1999 - 2004 WJ Jeep Grand Cherokees, and you can't really mistake this for any other body fastener I have seen.

It is fully functional when printed in any tuff filament with resistance to road/petrol solvents like gasoline, diesel, tar, oil, etc.

The insert is intended to be printed at the angle I modeled it with for layer strength.

There is no better way to say this next part without making it obvious I tried to avoid it, so keep your mind out of the gutter

It will fit tight at first, so pop the tab in and out a few times to loosen the slot before installing the retainer in it's hole.

Print Settings

I printed this with Overture Easy Nylon, on a .4mm nozzle @ .6mm line width (for extra squish/layer adhesion), at 0.1mm layer height (again for squish/layer adhesion), with 100% infill.

Post Processing

To harden the parts I put them in my cold oven, set it to bake at 70c/180f for 2 hours, then left it in the oven to cool slowly for several more hours.

Overture's site specifies the 70c and 2 hours.

Tags