1 / 15
Click Probe - To level your print bed
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
My vision of a probe to level the bed, but simpler than other designs
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 26
- Makes
- 0
- Views
- 1,046
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
It is a Klicky style probe for leveling the print bed, but simpler.
You will need: Four magnet that are 4mm thick, 6mm in diameter and press fitted.
One washer that goes on the back of the probe dock with some CA glue.
Two M3 Nuts and 2 M3 screws. Two small screws for mounting the switch to the probe.
One connector for your board of choice.
Some wire, are used to connect the magnet with the switch, and again from the magnets in the probe arm to the board. The wire are only soldered to the switch