1 / 3
Enclosure zip-tie-plugs  and 8mmx3mmx3mm-washer — image 1
1 / 3

Enclosure zip-tie-plugs and 8mmx3mmx3mm-washer

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Plugs for the zip tie holes and washers to aid plugging the round holes in the Original Prusa Enclosure

Rating
5 / 5
Likes
26
Downloads
155
Makes
7
Views
1,099
Reviews
4

Updated at source:

Model information

License
Creative Commons — Attribution

The Original Prusa Enclosure has many extra holes and zip tie hangers for customization as needed.  These are great, but the enclosure with all the holes wont build heat well.

To close the holes, I wanted something like the plastic push rivets that came with the enclosure.  They can be removed easily when needed.  I found the “Push Clip Rivet 3mm x 6.6mm PCB Circuit Panel Nylon Fastener” on Amazon.    These would plug the holes, but they are too long to plug it tightly.  To make it tight a washer is needed on the inside.  After a few tests I came up with a 8mm x 3.4mm x 3mm thick washer made out of PLA.   I used the washer on the inside of the hole and it made the push rivet tight in the hole.  

To close the zip tie holes I made a rectangular plug.  After a few tries adjusting the width of the plug by .1 mm I found a tight, but not too tight of a plug design.  It pushes into the zip tie holes, but not too deep.  You can still use the twist tie in the location.    See the pictures for the dimensions.

Sometimes the plug doesn't want to push in.  If I squeeze the plug a little with the needle nose pliers that came with the Prusa build kits, it will go in.  

.3mm layer height for the washer and .2mm for the zip tie plug. PLA    I built 100 of the washers and 48 of the zip tie plugs. 

Printing PETG the enclosure with the plugs installed held 33C, 11C over the ambient temperature.  There is more to be done to seal some other areas.

 

Tags