1 / 4
FPV Simulator thumb-stick
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I modeled some thumb-sticks for my Xbox one controller for Lift off; a FPV drone simulator.
- Rating
- 4.875 / 5
- Likes
- 75
- Downloads
- 651
- Makes
- 5
- Views
- 4,129
- Reviews
- 8
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I modeled some thumb-sticks for my Xbox one controller for Lift off; a FPV drone simulator. It has a 3mm screw hole in the mounts so if you want to make your own thumb-stick all you have to is make a thread 3-4mm deep thread to interface it. I recommend to run a 3mm through the hole first to make it easier to screw in the piece. I also made a curved connector not in the picture
Print instructions
print the thumb stick upside down along with the mount with supports