1 / 1
Parkside PHD pressure washer valve ... piston ... thingie?
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
NOTE: needs to be printed from nylon or some super stiff tpu, the stem is very fragile even when printed sideways.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 73
- Makes
- 0
- Views
- 1,016
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial
The base is a bit wider than the the original (worn down) part. I managed to reassemble the pump and the printed parts fit perfectly, but the thin stem where the little ring attaches broke apart in seconds.
I ran a few tests with the part printed as shown in pic, also sideways and angled with same results. Use something else than PETG.
I may or may not try to redraw the part from scratch at some point.