Odroid N2/N2+ and M1
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple case for Odroid N2 / N2+ or M1
- Rating
- 4.25 / 5
- Likes
- 21
- Downloads
- 270
- Makes
- 4
- Views
- 1,725
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
Simple case for Odroid N2, N2+ and M1 (their connector layout and the heatsink profile are very similar).
The M1 version is tall enough to allow an SATA SSD to be mounted (although I didn't use the original mounting kit).
The case keeps the heatsink in free air to ensure cooling stays unchanged. As shown in the pictures, the case can be used upright or flat on the desk.
Printing
I printed everything in PLA, the faceplates flat on the printbed, outside face down to make it as smooth as possible. The shell can be printed upright, relying on the fact that the printer can make the steep overhangs work.
Update 2026-03-02: Added a version of the faceplate for the side of the Odroid-N2 that has a 3.5mm jack and a switch, to better accommodate those two. Haven't tried it, but made the 3.5mm hole bigger by 0.1 mm and added 1.2mm to the hole with the switch in it, this should reduce the potential for collisions.
Renamed all the N2 files (what's an N1? I must have been confused). Also added the updated FreeCAD file (I needed to fix it for use with the FreeCAD 1.2 nightly I just started using, I hope it still works with older files.