1 / 1
Manual knob for OpenBulletFeeder
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A knob to manually crank an AmmoMike bullet feeder. (Does NOT work with the newer BF556 feeder!)
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 35
- Makes
- 0
- Views
- 486
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution
I was too lazy to wire up my OpenBulletFeeder motor and sensors when I got them, but still wanted automatic bullet placement, so I did up this little knob.
Not as good as a motorized bullet feeder, but a whole lot faster than setting each one by hand!
Print the parts in the given orientations. Attach the bar to the top of the knob with a sheet metal screw to hold it to the plate.
The .zip file is a FreeCAD project file. Change the extension to .FCStd to open it.