Counting matching models…
An OpenBulletFeeder shaft adapter for JGY370 motors, or any motor with a 6mm output shaft containing a threaded M3 hole. This design does not have an internal flat for the D-shaped output shaft. Clamp it to the shaft using an M3 screw…
I was too lazy to wire up my OpenBulletFeeder motor and sensors when I got them, but still wanted automatic bullet placement, so I did up this little knob. Not as good as a motorized bullet feeder, but a whole lot faster than setting each…
6.5 V2 Creedmoor Plate. Collating these very long boat tail 6.5mm are a challenge, they like to ride above, angle your feeder at 45 Degrees, the more in the collator, the better the result. For the original, smaller, OBF. Clutch plates…
223 Plate. I have made this by request, I have not tested it. It appears to work great, check out the video. Based on my 6.5 Creedmoor Plate. https://www.thingiverse.com/thing:3547180 Print 0.2 layer 0.4 nozzle 4 Side perimeters 3…
This is an adjustable and lockable 1” pipe mount for the openBulletFeeder. There are improvements from the one included in the openBulletFeeder. The Bullet Feeder mount side is modified from the OBF file, so the usual fitment issues from…
These are both Flip plates for 6.5mm, will flip your nose down. They should work with just about any rifle caliber, but I have not tested it beyond 6.5. This works with my 6.5 Collator Plate https://www.thingiverse.com/thing:3547180 These…
308 Plate. I have made this by request, I have not tested it. Based on my 6.5 Creedmoor Plate. https://www.thingiverse.com/thing:3547180 You will need to use my Flip plate/s for the nose down bullets.…
6.5 Creedmoor Plate. Collating these very long boat tail 6.5mm are a challenge, they like to ride above, angle your feeder at 45 Degrees, the more in the collator, the better the result. You will need to use my Flip plate/s for the nose…
This is a modification of the electronic mount from AmmoMike83's (all credit to him) OpenBulletFeeder, https://www.thingiverse.com/thing:2504314 , The Bullet Feeder mount side is modified from the OBF file, so the usual fitment issues…
The 6.5 Creedmoor Drop Tube Big Switch Small Spring from AmmoMike83's (all credit to him) OpenBulletFeeder, https://www.thingiverse.com/thing:2504314 , The one included in the project has the wrong ID of 0.258. I have corrected the ID,…
