4020 Fan Adapter for Bondtech LGX Shortcut on Mk3S
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Allows you to replace the stock 4010 fan on the LGX Shortcut with a 4020 fan as recommended by Bondtech.
- Rating
- 4 / 5
- Likes
- 14
- Downloads
- 46
- Makes
- 2
- Views
- 596
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution
I installed the Bondtech LGX Shortcut Mosquito hotend on my Prusa Mk3S and it worked well. That is until I put in in an enclosure, then the limits of the Shortcut's very short heatbreak became evident by the fact that i was getting jams due to heat creep. After some research I found that Bondtech recommends a 4020 fan where as in the Mk3 setup it uses a 4010 (they note that a 4010 "should work"). The problem is that simply swapping fans would cause a collision with the Z-axis bearings. This is my solution, it simply angles the fan in a way that it avoids the bearings. It seemed to do its job since I no longer have problems with jams when the enclosure heats up.
I attached the fan to the adapter with #4 thread rolling screws, but you could probably use anything that fits the hole, just know there aren't threads in the fan-to-adapter holes, so use a thread forming screw, wood screw, or something that will cut threads in the plastic. They are intentionally modeled smaller for this reason.
I also decided to take the opportunity to add a mount for a borescope nozzle camera. The camera mount is still a work in progress as the alignment isn't perfect, but it could work for you, if you already have a borescope then give it a try and see if it works for you. I included both versions if you just want the fan adapter.
I printed mine with the new Prusament PA11 Nylon and it worked great. I would think that PETG or even PLA would probably work fine since it has a fan constantly blowing thru the part, but it hasn't been tested.