Adafruit BME68X Case
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€0.57 – €0.70 net (excluding VAT)
For file: Deckel_Gehaeuse_PETG_MK3S_51m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.64 excluding VAT (range midpoint).
- Weight reported by the author
- 4 g
- Print time reported by the author
- 50.4 min
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A simple case for the Adafruit BME680/688 sensor boards. For use with a Qwiic-Connector.
- Rating
- 0 / 5
- Likes
- 18
- Downloads
- 161
- Makes
- 0
- Views
- 871
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
I've created a small and simple case for the Adafruit BME688 sensor board for use with a Qwiic-Connector (no cut-out for the pins).
I've printed it with Prusament PETG, not sure if other filaments will fit as PETG tends to shrink a bit.
The case features 4 pins that should fit the 4 holes in the board just right so no screws required.
Cover should be a tight fit so it doesn't pop out, might need some glue depending on the accuracy of your printer though.
Note: The cutout for the connector is actually to small for the connector to fit through, plug the connector in before installing the board. This is intentional, we have rubber cable sleeves that have the same dimensions at work.
The size of the cutout is 6.3 x 3.5 mm if you want to make a cover or similar.