Yaesu SMAJ to SMA antenna adapter sleeve
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Graduating from a Baofeng BF-F8 (UV-5R variant), to a Yaesu FT-1XD, I was faced with repurchasing quality antennas for…
- Rating
- 0 / 5
- Likes
- 23
- Downloads
- 134
- Makes
- 0
- Views
- 891
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Graduating from a Baofeng BF-F8 (UV-5R variant), to a Yaesu FT-1XD, I was faced with repurchasing quality antennas for it. With this adapter and a Male-Male SMA adapter, you can use the SMA-Female (often refered to as "J" style) antennas designed for the Baofeng on the Yaesu. I suspect this will work with most other Yaesu radios as well, but have not tested any. Feel free to customize as you see fit.
Tip: print just a 5mm height section to test-fit until you have the extrusionSquish parameter dialed in for your printer.
Print instructions
Category: Electronics Summary
Graduating from a Baofeng BF-F8 (UV-5R variant), to a Yaesu FT-1XD, I was faced with repurchasing quality antennas for it. With this adapter and a Male-Male SMA adapter, you can use the SMA-Female (often refered to as "J" style) antennas designed for the Baofeng on the Yaesu. I suspect this will work with most other Yaesu radios as well, but have not tested any. Feel free to customize as you see fit.
Tip: print just a 5mm height section to test-fit until you have the extrusionSquish parameter dialed in for your printer.
Print Settings
Printer Brand: Printrbot
Printer: Simple White
Rafts: Doesn't Matter
Supports: Doesn't Matter
Resolution: 200 microns
Infill: 100%
Notes:
Set to 10 shells so all paths are concentric